The realization of a jewel requires above all studies. Your idea gradually becomes a sketch and then a sketch and finally a synthetic image drawing which perfectly corresponds to your request. This time of creation and research is the most important: it will define the stones used, their colors, the metal, the shapes, the structure ...
The jeweler begins his work from a Lingotin which is debited in plate or thread with established coasts. Tolerances are from the tenth to the hundredth of a millimeter. This precision will make the quality and perfection of your future jewel. The pieces are then forged, laminated, turned with the pliers to give the chosen shape.
The creation of the basket will hold the center of the center. It is he who will be the main element around which the ring will be made. Two rings are turned, one of 3 to 4 tenths of a millimeter lower than the diameter of the stone, the other, slightly stamped in order to take a rounded shape, will be placed on the finger.
Once the basket is finished, it is the turn of the manufacture of the body. Due to its structure, it will have to maintain it and be resistant to possible shocks. In order to ventilate the ring, the decor on palmettes is made. Four lines of diamonds will be set on them.
Finally, it is the adjustment of the basket on the body. Extremely long part which will require several hours of work from the jeweler. The designer will remove the metal hundredth from a millimeter per hundredth of a millimeter using a strawberry. The head should be perfectly adjusted according to the three axes of symmetry. Then, it is the turn of the pierrage, each diamond will be housed in a hole which will be attributed to it.
After the jewelry finishes, the ring will pass between the magic fingers of the setting. This very specific job is to keep stones in metal. This art, very often forgotten and unknown to the general public, will transform this raw, pierced and decorative structure on ee into a jewel that will sparkle at the center of a setting ...